Blog

Frequently Asked Questions

  • Post author:
  • Post category:FAQs

Image Problems

  • LED Indicator 1 OFF: Check whether the cable is connected correctly to the power adaptor (DC 5V/ 1.5A or greater output).

  • LED Indicator 1 blinks rapidly: Unplug and plug the cable to restart the device. If same case happened, please replace other power adapter (DC 5V/ 1.5A or greater output), then connect it again.

  • LED Indicator 1 OFF & LED Indicator 2 flashes every 3 seconds: The projector enters standby status at the specified time, when no signal output from the video source device. Please awake the projector by resuming signal or press the jog lever.

  • LED Indicator 1 remains on & LED Indicator 2 OFF: Check whether the HDMI cable is connected correctly or loose in both input/ output terminal.

  • LED Indicator 1 remains on & LED Indicator 2 OFF: Check whether the video source (Output) is sending the content to the projected device (Input) correctly.

  • Check whether the native projected image is output abnormal.

  • Unplug and plug again the cable from the device to restart. 

  • Unplug and plug again the cable from the device to restart.

  • Replace other power adapter (DC 5V/ 1.5A or greater output), and reconnect the device to restart.

  • Remove any metal or magnetic material from the device, then unplug and plug it again to restart.

  • Check whether there‘s any source of vibration (e.g. speaker, vibration will cause abnormal function of MEMS).

  • Hold down the jog lever for 3 seconds to enter the OSD mode. Select [Sharpness] to adjust.

  • Laser speckle. The speckle effect is a result of the interference of many waves of the same frequency. Refer to the following for the details:

    https://en.wikipedia.org/wiki/Speckle_pattern

     

    Anybeam is a MEMS laser scanning projector which has many advantages from MEMS laser scanning, but also has the limitations of this new technology.

  • Hold down the jog lever for 3 seconds to enter the OSD mode. Select [Green/ Blue Alignment] to adjust.

  • Make sure the lens is clean with no dust and check again.

  • AnyBeam suggests 720p resolution input. Some other resolution may not be projected.

  • Unplug and plug again the cable from the device to restart, and check whether the problem is solved.

Audio Problems

  • Check video source to make sure the volume is turned up and the audio content is not mute.
  • Slide the jog lever to ← or → to check the volume level of the projector.
  • Unplug and plug again the cable from the device to restart, and check the problem is solved.
  • Hold down the jog lever for 3 seconds to enter the OSD mode. Select [AUDIO SOURCE SETTING/ LINE OUT] to force the audio to output from the connected speakers.